In this article I provide you online dummy practice test for ccna 200-301. The questions of this article practice test for ccna 200-301 may be helpful you to check your knowledge about networking or ccna exam 200-301. This test for ccna 200-301 contains a 10 questions mcq related to IP connectivity. There are many online websites and books available for Practice for ccna 200-301 exam. You can found these resources easily via any online search engine like google or yahoo etc. Along with these resources attempt the test for ccna 200-301 on this website may be helpful you to build confidence and check your knowledge.
How to attempt this Practice test for ccna 200-301 set 52
This article have 10 questions with multiple answers. You need to select the correct answer and at the end of the quiz just click on the button “click to check your answer”. A message will prompt on your screen with the exam score. You can also see the correct answers on page. So play the below quiz and do a dummy test for ccna 200-301 to check your knowledge about ccna 200-301 exam. At the end of this article link available for next or previous quiz. The complete list of all quiz is available for dummy test for ccna 200-301 here.
-
1. Why the command "Sw(config-int)#no switchport" used in switch?
A) The command changed the mode of the port to routed interface.
B) The command changed the mode of the port to access interface.
C) The command changed the mode of the port to trunk interface.
D) The command changed the mode of the port to poratble interface.
-
2. How can we configure 4 intrfaces to route 7 VLANs?
A) Configure static routing protocol.
B) Configure dynamic routing protocol.
C) Remove the ROAS feature from the router.
D) Using router as ROAS.
-
3. Which command allow routing between VLANs in a switch?
A) Sw(config)#ip route.
B) Sw(config)#ip routing.
C) Sw(config)#route vlan 10.
D) Sw(config)#ip vlan routing.
-
4. Which trunking protocol supports routing between VLANs with router interfaces?
A) 802.1W.
B) 802.1Q.
C) 802.1AW.
D) VTP.
-
5. Which command used to configure an interface of the ROAS as the native VLAN?
A) Router(config-if)#encapsulation dot1q 2 native vlan.
B) Router(config-if)#encapsulation dot1q 2 native.
C) Router(config-subif)#encapsulation dot1q 2 native vlan.
D) Router(config-subif)#encapsulation dot1q 2 native.
-
6. Which command used to configure IP address on SVI(Switch Virtual Interface)?
A) Switch(config)#interface vlan 20
Switch(config-if)#ip address 190.160.1.1 255.255.255.0
Switch(config-if)#no shutdown
B) Switch(config-if)#interface vlan 20
Switch(config-if)#ip address 190.160.1.1 255.255.255.0
Switch(config-if)#no shutdown
C) Switch(config)#interface set vlan 20
Switch(config-if)#ip address 190.160.1.1 255.255.255.0
Switch(config-if)#no shutdown
D) Switch(config-if)#interface vlan 20
Switch(config-if)#ip address 190.160.1.1 255.255.255.0
Switch(config)#no shutdown
-
7. Which mode is required for an interface to be configured during confiuguration of ROAS?
A) Portable.
B) Access mode.
C) Trunk mode.
D) None of the above.
-
8. Which of the following is best practice when naming the subinterface during configuration of ROAS?
A) Same as IP address.
B) Same as VLAN number.
C) Same name as VLAN.
D) Same as network ID to identify the network ID.
-
9. Which command direct the frames for an individual VLAN's subinterface?
A) Router(config-subif)#encapsulation dot1q vlan 5.
B) Router(config-subif)#encapsulation dot1q 5.
C) Router(config-if)#encapsulation dot1q 5.
D) Router(config-subif)#encapsulation vlan 10.
-
10. Which of the following command enable IP routing on 2960-XR switches?
A) Sw(config-if)#sdm prefer lanbase-routing.
B) Sw(config)#sdm prefer lanbase-routing.
C) Sw(config)#sdm prefer routing
D) Sw(config)#sdm prefer lanbase.
Attend all Practice exam for ccna 200-301 on this site. Every quiz on this website have different questions there are approx 200 quiz available here on this site for Practice exam for ccna 200-301. for explanation of any question you may explore our website via this link. This website covers almost topics of CCNA 200-301.
I hope you found this Practice exam for ccna 200-301 interesting and useful. You can take more Practice test for ccna 200-301 on this website. For any query or suggestions you may drop a comment below or contact us. Read more articles for CCNA on this site. Share this webpage in your social circle by the icons below.
