MCQ for STP set 3

This blog contains a 10 questions mcq for STP. you can check your knowledge about STP basic by playing the below quiz . you need to select the correct answer from below quiz. There is a button at the end of this page to check your result. The button will show you your score and correct answers. You can check your knowledge about the STP basics.


  • 1. What is used by STP to select the port to shut down ?


    A) Mac address.

    B) IP address.

    C) Bandwidth.

    D) Media.

  • 2. What is the range of bridge priority on cisco switches ?


    A) 1 to 61440.

    B) 0 to 61440.

    C) 10 to 61440.

    D) 10 to 61444.

  • 3. What is the IEEE standard of Rapid Spanning Tree Protocol (RSTP) ?


    A) 802.10w.

    B) 802.1q.

    C) 802.1d.

    D) 802.1w.

  • 4. The spanning converging time is approx ?


    A) 40 seconds.

    B) 120 seconds.

    C) 160 seconds.

    D) 50 seconds.

  • 5. The ’50 series switches switch port can support only ?


    A) 159 MAC Address.

    B) 198 MAC Address.

    C) 192 MAC Address.

    D) 149 MAC Address.

  • 6. Which of the following is command to check the rstp status ?


    A) show spanning.

    B) show spanning-tree.

    C) show rstp.

    D) show run.

  • 7. Which command used to display the forward/filter table used on the LAN switch ?


    A) Show forward table.

    B) Show filter table.

    C) show mac addresstable.

    D) none of the above.

  • 8. What will switch do if the MAC address is not found in its mac address table ?


    A) Flood the frame out all ports.

    B) Delete the frame itself.

    C) Search for mac address in the network.

    D) None of the above.

  • 9. Which of the following command used to run the new 802.1w on switches ?


    A) spanning-tree rapid-pvst.

    B) spanning-tree mode.

    C) Spanning-tree mode rapid-pvst.

    D) mode rapid-pvst.

  • 10. What is populated by port in learning state ?


    A) MAC address table.

    B) IP address table.

    C) Both A and B.

    D) Nothing is populated.



I hope you found this mcq for STP quiz interesting and useful. For any query or suggestions you may drop a comment below or contact us. Read more articles for CCNA on this site. Share this webpage in your social circle by the icons below.

Share this article in your social circle :)
You may also like to read --  MCQ for IP Routing set 7
,

1 thought on “MCQ for STP set 3

  1. That is really interesting, You are an excessively skilled blogger.
    I’ve joined your feed and sit up for seeking more of your wonderful post.
    Also, I have shared your website in my social networks

    Visit my homepage cbd gummies

Leave a Reply

Your email address will not be published. Required fields are marked *